Installation of ink cartridge into printer?

how to install cartridge into printer.HP ALL IN ONE 5200 SERIESInstallation of ink cartridge into printer?
hold the cartilage and insert it on cartilage socket keep your finger down so that the end point(you see the ink opening point ) will slightly up.now apply some force so that it will set on its place now up your finger and a snap voice come. its mean your cartilage fit in its place. avoid applying too much force otherwise it will break.Installation of ink cartridge into printer?
I copied this directly from your printers user manual. You can see these instructions with photographs to help you at the source below.











How to Replace the print cartridges





Follow these instructions when you need to replace print cartridges.


NOTE: When the ink level for the print cartridge is low, a message appears on the display. You can also check the ink levels by using the Printer Toolbox available through the HP Photosmart Software on your computer or through the Print Properties dialog box on your computer.





If you do not already have replacement print cartridges for the HP All-in-One, you can order them by clicking the Shop for HP Supplies icon on your computer. On a Windows computer this is located in the HP folder in the Start menu. For more information see www.hp.com/buy/supplies.





To replace the print cartridges





1. Make sure the HP All-in-One is on.





CAUTION: If the HP All-in-One is off when you open the print cartridge door to access the print cartridges, the HP All-in-One will not release the cartridges for changing. You might damage the HP All-in-One if the print cartridges are not docked safely when you try to remove them.





2. Open the print cartridge door.





The print carriage moves to the far right side of the HP All-in-One.





3. Wait until the print carriage is idle and silent, and then lightly press down on a print cartridge to release it. If you are replacing the tri-color print cartridge, remove the print cartridge from the slot on the left.





If you are replacing the black, photo, or gray photo print cartridge, remove the print cartridge from the slot on the right.





4. Pull the print cartridge toward you out of its slot.





5. If you are removing the black print cartridge in order to install the photo or gray photo print cartridge, store the black print cartridge in the print cartridge protector or an airtight plastic container.





6. Remove the new print cartridge from its packaging and, being careful to touch only the black plastic, gently remove the plastic tape by using the pink pull tab.





7. Hold the print cartridge with the HP logo on top, and insert the new print cartridge into the empty cartridge slot. Make sure you push the print cartridge in firmly until it snaps into place.





If you are installing the tri-color print cartridge, slide it into the left slot.


If you are installing a black, photo, or gray photo print cartridge, slide it into the right slot.





8. Close the print cartridge door.





If you installed a new print cartridge, the HP All-in-One prints a print cartridge alignment page.





9. When prompted, ensure plain white paper is loaded in the input tray, then press OK.





10. The HP All-in-One prints a test page, aligns the print head, and calibrates the printer. Recycle or discard the page. A success or failure message appears.





NOTE: If you have colored paper loaded in the input tray when you align the print cartridges, the alignment will fail. Load unused plain white paper into the input tray, and then try the alignment again.


If the alignment fails again, you might have a defective sensor or print cartridge. Contact HP Support. Go to www.hp.com/support. If prompted, choose your country/region, and then click Contact HP for information on calling for technical support.





11. Press OK to continue.